Sigma 3D2 SERIES 3 Tile Cutter
Quality Sigma manual tile cutter-Made in Italy
The Sigma 3D2 SERIES 3 Tile Cutter is one of the original tile cutter models that has been produced by Sigma since the company was founded in 1969. This manual tile cutter is suitable for cutting a range of tiles up to 20mm thick.
This Sigma Tile Cutter has a tungsten carbide scoring wheel and scores the tile by pulling the breaker along the surface of the tile. Pushing the breaker handle downwards quickly breaks the tile while the sprung-loaded base plates of the tile cutter absorb the impact.
The Sigma 3D2 SERIES 3 Tile Cutter has a swivelling measurement bar which rotates through 45 degrees in both directions with a scale to accurately determine the angle of cut. This measurement bar features two scales to allow the length of tile to be measured from the centre of the cutting line in either centimetres or inches.
This new version Sigma 3D2 SERIES 3 Tile Cutter includes the quick-change system on the guide rail allowing the handle type to be changed to a Max or Klick Klock if required. These extra handles are not supplied with this manual tile cutter and must be purchased separately.
The Sigma 3D2 SERIES 3 Tile Cutter weighs 13.5kg.
The maximum straight cut length is 95cm and diagonal cuts can be made on tiles measuring up to 67x67cm.
This model of Sigma tile cutter has a breaking Strength of 1050kg.